Description
Durable, solvent-resistant paint for the bilge.
PETTIT PAINT EZ Bilge Paints - Quart Gray. Formulated to withstand the abusive conditions encountered in boat bilges, this high-performance alkyd finish produces a durable coating that is resistant to antifreeze, grease, gasoline, diesel fuel, and engine oil. Creates a tough resilient surface that stands up to years of abrasion and wear.
Key Features
- Performance coating uniquely designed for boat bilges
- Resistant and tough on fuel and oil spills
- Abrasion resistant with a resilient surface
- Utilizes a high-solids formula that is easy to brush or roll in difficult spaces
Physical Data
- Type: Oil modified Alkyd
- Finish: High gloss
- Available colors: White, Grey
- Components: 1
- Curing mechanism: Solvent Release
- Solids by Volume: 51.0% +/- 2% (Theoretical)
- Solids by weight: 65.0% +/- 2% (Theoretical)
- Coverage: 545sq. ft. /gal.
- VOC: 388 g/l Max. (as supplied)
- Active ingredients: Cuprous Oxide 40.5%
- Flash point: 110° F
Application
- Application Method: Brush, roller or spray
- Number of coats recommended: 2 Coats
- Wet Film Thickness: 3.0 mils
- Dry Film Thickness: 1.5 mils
- Applicator: High-quality short nap roller (maximum 3/8” nap) brush
- Application temperature Min. /Max. Range: Minimum 50°F and Maximum 90°F.
- Thinner: 120 Brushing, model 249961
Drying Times*(Hours)
| Drying | @50°F | @70°F | @90°F |
|---|---|---|---|
| To Touch | 6 hr. | 3 hr. | 1-1/2 hr. |
| To Recoat | 24 hr. | 16 hr. | 8 hr. |
*The above dry times are minimums. May be recoated after the minimum time shown. There is no maximum dry time before launching.
Another way to determine bottom paint quantity is to estimate the approximate surface area of the hull below the waterline, using the following formula:
Length x Beam x .75 = Approximate underwater surface area in square feet.
Each paint has a “theoretical coverage” area, but most paints require at least two coats, so you can expect actual coverage to be no greater than half of the theoretical value.
NOTE: Manufacturer data sheets are subject to revision. Linked data sheets are believed to be accurate at the time of publication.
Specifications
- Hazardous Shipping:
- This item has D.O.T. Hazard Shipping Restrictions and cannot be shipped in the air. It can be ordered online for shipment by Ground Shipping Methods
- Color Disclaimer:
- We try extremely hard to ensure our photos are as life-like as possible, but please understand the actual color may vary slightly from your monitor.
- California Residents:
- Cancer and Reproductive Harm - www.P65Warnings.ca.gov
- Capacity:
- 1 Quart
- Color:
- Gray
- Coverage:
- 136 Square Feet/Quart
- Cure Time:
- To Recoat: 8-24 Hours; To Touch: 1 1/2-6 Hours
- Type:
- Alkyd-Based Enamel
